This is a brand new electric gear motor that has an extremely high torque and is speed adjustable with a PWM (Pulse Width Modulating) controller. The gear motor is measured to be 7 inch long and the motor itself has a diameter of 2.5 inches. Drive shaft is 10mm...
This is a brand new electric gear motor that has an extremely high torque and is speed adjustable with
a PWM (Pulse Width Modulating) controller. The gear motor is measured to be 7 inch long and the
motor itself has a diameter of 2.5 inches. Drive shaft is 10mm in diameter with 2 flats where flat to flat is
6mm. The shaft has a threaded end that is to fit a M6 tightening nut. Rated voltage of this gear motor is
13.5 VDC and maximum speed is 50 RPM. Rated output load is 60 watts and output toruqe at 50 RPM
is 11.5 N-m (8.5 ft-lb). Mounting is based on M6 screw mounting. The 12V DC PWM controller features
a 4 ft(1.2m) long connection to its potentiometer. The potentiometer has a on/off switch built-in with a
knob. An overload protection is set at 6 amps of current so the controller will shut down when such a
current occurs. There are connectors between the gear motor and the controller. To run the gear motor
in CW rotation, please connect motor's green connector to controller's red connector and motor's red
connector to controller's black connector. To run the gear motor in CCW rotation, please connect
motor's green connector to controller's black connector and motor's red connector to controller's red
connector. The distance of the connection wires between the motor and the controller is 1 ft(30cm). The
distance of the 12v connection wire is 10 in(25cm) long.
Manufacturer: Wondermotor
Manufacturer: N/A
MPN: PN00409
SKU: N/A
Sign In
