SKU: AVE

The Auto Vision System is a full three dimensional system for accurate body and frame repairs. With the Auto Vision fully computerized system measuring commands and data can be accessed from both the hand held computer and the touch screen. The Auto Vision System can be mounted to any Frame Rack. And also does 4 wheel alignments. We have the option to add a second set of rails so you can use it on your frame rack and your alignment rack.

The AUTO-VISION three dimensional measuring system is easy to use. The system is permanently attached to the frame rack which means no wasted time assembling or disassembling the system, not to mention trying to find a place to store a measuring system and all of its components. All of the components needed to measure a vehicle, from the underbody to the upper body to wheel alignment, can be found on the system. No searching for attachments! Simply pull the car on the frame rack, place it in the clamps, and begin to diagnose and repair. The underside of the vehicle is fully exposed. Continue to measure while you work, without having to work around the measuring system.

Moving from one area of the vehicle to another is simple and straightforward. No need to add pieces and parts to construct extensions to measure different areas of the vehicle. Measure underbody, under hood, upper body and perform a complete four wheel alignment with speed and accuracy. In fact, the fifteen foot extruded aircraft aluminum rails, while being sturdy enough to support the weight of seven adult males, hold extremely tight tolerances over the length of the rail. Sealed bearings ride on a track inside of the rail to protect them from damage and withstand the harsh environment of the body shop. Telescoping arms reach all locations. Nearly any bolt, hole, or seam can be measured by using either data charts or a comparison of points from side to side.

Isolate the area where damage exists, place the width arm in the proper measuring location and begin pulling the vehicle while using AUTO-VISION to monitor the pull. Get precise repairs the first time, with no over pulling. It is that easy. Then, when one area is repaired, move to another section in seconds. Repair times are reduced drastically. Furthermore, once the damage has been repaired, perform a complete wheel alignment on the vehicle to ensure the repairs were made correctly. Check Camber, Caster, Toe, Thrust Angle, Tracking and SAI with AUTO-VISION and keep wheel alignment revenue in house.