SKU: ESD26SBPF

Side Downdraft Automotive Booths

-EZ to Install

-EZ to Operate

-EZ to Maintain

-EZ to Pressurize

No Pit Needed

The Downdraft Booth intakes fresh air from the cleaner upper levels of the shop through a filter bank in the booth ceiling. The filtered air is drawn down and away from the vehicle through exhaust filters at the floor level, along both sides. This provides efficient overspray control that reduces prep time and also provides a much healthier workplace environment without an expensive downdraft exhaust pit. When purchases as a pressurized unit, the booth can be equipped with an air replacement unit and cure cycle to meet your requirements. It is available in both drive-through and solid-back design.

Lighting Features

Bright full booth illumination is provided by ten four-tube, 48”, 32-watt, fluorescent light fixtures in the angled ceiling panels and side walls. Each is sealed behind clear, tempered safety glass. All fixtures are UL listed and approved for their intended use and placement. The light tubes are not furnished with the fixtures.

Construction Features and Quality Standards

All booth and plenum sections are made with 18-gauge galvanized steel. All product and personnel access doors are pre-hung in heavy gauge galvanized steel frames for easy installation. Brixon latches are provided for each door opening.

Exhaust is provided by two 24” diameter tubeaxial fan with a 2 HP, three-phase motor.

All hardware, filters and sealants needed for the booth installation are included. The control panel and other electrical components may be purchased separately.

ESD26SB:

Interior Dimensions: 14’W x 9’H x 26’L

Exterior Dimensions: 16’4”W x 9’4”H x 26’4” L

Access Door: 1

Nominal Door Opening: 9’4”W x 8’10.5”H

Fluorescent Lights: 10

Add Powder Coating For Only $1,779.00

Call for a list of available options 1-800-637-4027

Ships direct from Manufacturer, you will be contacted for the shipping charges

Colmet